How to use the Curtain Fabric Yardage Calculator
How to measure
- Get the rod or track width and the full finished length (use the Curtain Length and Width & Fullness calculators first if you have not).
- Check the fabric width on the bolt or listing — commonly 54 in (137 cm) for curtain fabric.
- If the fabric has a pattern, find the vertical pattern repeat on the listing (the distance before the design repeats).
- Enter your heading and hem allowances, seam/selvedge allowance and a waste percentage for straightening and cutting.
The formula
Usable fabric width = fabric width − seam and selvedge allowanceFabric widths per panel = (rod width × fullness ÷ panels) ÷ usable width, rounded upTotal drops = widths per panel × panelsCut length = finished length + heading + hem, rounded up to a whole pattern repeatFabric to buy = total drops × cut length × (1 + waste %), rounded up (to ¼ yd or 0.1 m)
Widths are always rounded up to whole widths — you cannot buy part of a fabric width — and every drop must start at the same point in the pattern so panels match.
Worked example
A pair of curtains for a 72 in rod, 84 in finished length, 2× fullness, 54 in plain fabric, 2 in seam allowance, 8 in heading, 8 in hem and 5% waste:
Total flat width = 72 × 2 = 144 in, so each panel needs 72 in. Usable width is 54 − 2 = 52 in, so each panel needs 72 ÷ 52 = 1.38 → 2 widths, and the pair needs 4 drops.
Cut length = 84 + 8 + 8 = 100 in. Fabric = 4 × 100 × 1.05 = 420 in = 11.67 yd, rounded up to buy 11.75 yd.
With a 27 in pattern repeat, each drop rounds up to 108 in (4 repeats): 4 × 108 × 1.05 = 453.6 in = 12.6 yd, so buy 12.75 yd.
Common mistakes to avoid
- Ignoring the pattern repeat. Patterned fabric often needs 10–25% more than plain fabric to match across panels.
- Using the full fabric width instead of the usable width after seams and selvedges.
- Rounding fabric widths down. Half a width usually means joining an awkward narrow strip.
- Ordering fabric from different dye lots. Buy everything at once to avoid colour differences.
Frequently asked questions
How many yards of fabric do I need for curtains?
Multiply the number of fabric drops by the cut length of each drop, then add a waste allowance. For a pair on a 72 in rod at 84 in long with 54 in fabric, that is about 11.75 yd of plain fabric.
How much extra fabric do I need for a pattern repeat?
Each drop is rounded up to a whole number of pattern repeats so the design lines up. The larger the repeat, the more extra fabric you need — often an extra repeat per drop.
What is a fabric drop?
A drop is one full-length piece of fabric cut for a curtain. Wider curtains join several drops side by side.
Does this include lining?
No. Lining is usually calculated the same way but without a pattern repeat and with slightly smaller allowances. Run the calculator again with the lining width and zero pattern repeat.